Zero Point Calibration 4 Runner. Optional method one: Zero Point Calibration Using Jumper wire The following manual procedure may be used in the cases where a Diagnostic Tester is not available. I just had the reason the check engine lights came on for it, but the calibration was not.
It will also be neccessary to perform after installing bigger tires, lift kits and after. This worked for me and I. CAUTION: While performing the Zero Point Calibration, do NOT tilt, move, or shake the vehicle.
This worked for me and I.
You can do the calibration by clicking Engine and ECT > > special function > > and then click.
CAUTION: While performing the Zero Point Calibration, do NOT tilt, move, or shake the vehicle. Although you have three different calibrations, we are only going to calibrate two. If GPS reception is poor due to location, you can manually adjust the current vehicle position mark. ' By calibrating the VSC, aren't you setting the new "zero point"?
Komentar
Posting Komentar